Pit Boss PLATINUM LAREDO 1000 PB1000PL Manual De Instrucciones página 16

ACT
SET
NO PELLETS
ACT
ROBE 1 PROBE 2
SET
PRIME
PROBE 1 PROBE 2
ACT
SET
PRIME
PROBE 1 NO PELLETS
PROBE 1 PROBE 2
ACT
SET
ACT
PROBE 1
SET
PROBE 1 PROBE 2
NO PELLETS
PROBE 2
CONTROL BOARD FUNCTIONS
E 2
• SETTING THE GRILL TEMPERATURE
The Grill Probe measures the internal temperature of the Main Barrel. When the Set temperature is adjusted, the Grill Probe
will read the Actual temperature inside the Main Barrel and adjust to the desired Set temperature.
IMPORTANT: The temperature of your unit is highly dependent on ambient outdoor weather, quality of pellets
used, flavor of pellets, and the quantity of food being cooked.
SETTING/ADJUSTING THE SET TEMPERATURE
To adjust the desired Set temperature of the grill, follow the steps below:
1. Press the Controller Knob. This will make the Set temperature readout blink, to show it is active.
2. Use the Controller Knob again to adjust to your desired temperature.
3. Once the desired Set temperature is reached, press the Controller Knob to confirm the Set temperature,
then the readout will return back to the Actual Temperature.
16
The Flame icon visually displays the intensity of the fire in the burn pot. As the temperature increases
from within the Main Barrel, the color of the Flame will turn from blue to red. The color will also change
when you are adjusting the Set temperature.
The central readout displays both the Actual and Set temperatures. The Actual temperature is constantly
displayed unless the Set temperature is being adjusted. The Actual temperature is the temperature
from inside the Main Barrel. The Actual temperature readout is taken by the grill probe (sensor) from
the inside of the grill barrel.
NO PELLETS
To show the Set temperature, press the Controller Knob. The Set temperature is active when the readout
ACT
is blinking. To adjust the Set temperature, rotate the Controller Knob, as needed. Once the desired Set
SET
temperature is reached, press the Controller Knob to confirm the Set temperature, then the readout will
return back to the Actual Temperature.
ACT
NO PELLETS
SET
PROBE 2
Displays the Actual temperature of a Meat Probe (MP). These two Meat Probe readouts correspond with
the plug-in connection port selected. When not in use, disconnect the Meat Probe from the connection
ACT
port and code "noP" will be displayed. Compatible with Pit Boss® Grills branded meat probes only.
SET
The AUGER icon is visible when the auger is turning. When the central readout has an error code (Err) and
the AUGER icon is blinking, the auger is not working. See the section on troubleshooting for assistance.
The IGNITER icon is visible when the igniter is in use. When the central readout has an error code (Err)
NO PELLETS
and the IGNITER icon is blinking, the igniter is not working. See the section on troubleshooting for
PROBE 2
assistance.
The FAN icon is visible when the fan is in operation. When the central readout has an error code (Err)
NO PELLETS
and the FAN icon is blinking, the Fan is not working. See the section on troubleshooting for assistance.
When the central readout has an error code (Err) and the NO PELLETS is visible, the fire in the burn pot
has gone out and the hopper may be empty. See the section on troubleshooting for assistance.
NO PELLETS