Auger Priming Procedure; First Use - Grill Burn-Off; Automatic Start-Up Procedure; Shutting Off Your Grill - Pit Boss PLATINUM LAREDO 1000 PB1000PL Manual De Instrucciones

Ocultar thumbs Ver también para PLATINUM LAREDO 1000 PB1000PL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FIRST USE – GRILL BURN-OFF
Once your auger has been primed and before cooking on your grill for the first time, it is important to complete a grill burn-off.
Start the grill and operate at any temperature over 176°C / 350°F (with the lid down) for 30 to 40 minutes to burn-off the grill
and rid it of any foreign matter.

AUTOMATIC START-UP PROCEDURE

1.
Plug the power cord into a grounded power source. Open the main barrel lid. Check the burn pot to ensure there is no
obstruction for proper ignition. Open the hopper lid. Ensure there are no foreign objects in the hopper or auger feed
system. Fill the hopper with dry, all natural barbecue hardwood pellets.
2. Press the Power Button to turn the unit on. This will activate the start-up cycle. The auger feed system will begin to turn,
the igniter will begin to heat and the fan will supply air to the burn pot. The grill will begin to produce smoke while the
start-up cycle is taking place. The barrel lid must remain open during the start-up cycle. To confirm the start-up cycle has
begun properly, listen for a torchy roar, and notice some heat being produced.
3. Once the heavy, white smoke has dissipated, the start-up cycle is complete and you are ready to enjoy your grill at your
desired temperature!

SHUTTING OFF YOUR GRILL

When finished cooking, with the main barrel lid remaining closed, press and hold the the Power Button for three seconds to
Power-down the unit. The grill will begin its automatic cool-down cycle. The auger system will stop feeding fuel, the flame will
burn out, and the fan will continue to run until the cool-down cycle is complete.
IMPORTANT! Once the shut-down cycle is complete, unplug the power cord.

RAISING/LOWERING THE FRONT SHELF

To raise, lift the Front Shelf into a horizontal position
for use. The locking latches of the Front Shelf will lock
into place.
To lower, squeeze the locking latches upwards to
release the Front Shelf, then push the Front Shelf into
its storage position.
18

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

1071210880

Tabla de contenido