Installing The Cooking Components; Placing The Grease Bucket; Connecting To A Power Source - Pit Boss PLATINUM LAREDO 1000 PB1000PL Manual De Instrucciones

13. INSTALLING THE COOKING COMPONENTS

Parts Required:
1 x Top Cooking Grate (#1)
1 x Middle Cooking Grate (#2)
2 x Cooking Grate (#3)
Installation:
• Place the cooking grate, side-by-side, on the grate ledges inside the
main barrel. Place the middle cooking grate on the middle ledge inside
the main barrel. Place the top cooking grate on the top ledge inside
the main barrel. The cooking grate will lock into place.
NOTE: To maintain the searing and grilling performance of your
cooking grate, regular care and maintenance is required.

14. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#18)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
• The unit is now completely assembled.

15. CONNECTING TO A POWER SOURCE

• STANDARD OUTLET
This appliance requires 110-120 volt, 60Hz, 275W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from
the igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
IMPORTANT: Disconnect unit from power source when not in use.
12
13
1
2
3
14
15
18