Cameo S4 IP Manual De Usuario página 18

SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press the right rotary-push encoder to enter the main menu.
Rotate the left encoder (SELECT) to select the menu item DMX Address (see left arrow) and
confirm by pushing the encoder (ENTER). You can now configure the DMX start address as
required by rotating the left encoder (the highest value depends on the selected DMX mode).
Confirm the entry by pressing the left encoder (ENTER), which will also automatically return you
to the main display and activate DMX mode. At the same time, the following DMX start address
(Next Free Address) is displayed for the selected start address plus channel number of the
selected DMX mode. The menu item for selecting the desired DMX mode can be reached directly
from the DMX Address menu item by pressing the middle rotary-push encoder (DMX mode); the
previously set DMX start address is automatically saved.
CONFIGURING DMX MODE
Starting from the main display, press the right rotary-push encoder to enter the main menu
(MENU). Rotate the left encoder (SELECT) to select the menu item DMX Mode (see left arrow)
and confirm by pushing the encoder (ENTER). You can now select the desired DMX mode by
turning the left encoder. Confirm the selection by pressing the left encoder (ENTER), which will
also automatically return you to the main display and activate DMX mode. The menu item for
setting the desired DMX start address can be reached directly from the DMX Mode menu item
by pressing the middle rotary-push encoder (DMX address); the previously selected DMX mode
is automatically saved. Tables with the channel assignment of the different DMX modes can be
found in these instructions under DMX CONTROL.
ENABLE EXTERNAL CONTROL BY DMX, ARTNET AND SACN
Starting from the main display, press the left push button rotary encoder to access the menu for
selecting the mode. Rotate the left encoder (SELECT) to SELECT DMX (see left arrow) and confirm
by pressing the left encoder (ENTER). The control protocol preselected in the Protocol menu item
in the main menu is now activated (DMX512 / Artnet / sACN).
To configure the two control protocols ArtNet and sACN as desired, press the right encoder
(menu), then select Protocol and confirm (Enter). Select the desired protocol, confirm, then select
the submenu items for setting and confirm again (see table).
18