Operation - Husqvarna MADSAW 525iDEPS Powerhead Manual De Usuario

Introduction
WARNING:
understand the safety chapter
before you use the product.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of
the product. The battery locks into position
when you hear a click.
CAUTION:
does not move easily into the
battery holder, the battery is
not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed
correctly.
To charge the battery
Note:
Charge the battery if it is the first time
that you use it. A new battery is only 30%
charged.
1. Make sure that the battery is dry.
16

Operation

Read and
Only use Husqvarna
If the battery
2. Put the battery in the battery charger.
3. Make sure that the green charging light on
the battery charger comes on. That means
that the battery is connected correctly to
the battery charger.
4. When all LEDs on the battery come on, the
battery is fully charged.
5. To disconnect the battery charger from the
mains socket, pull the plug. Do not pull the
cable.
6. Remove the battery from the battery
charger.
Note:
Refer to the battery and battery
charger manuals for more information.
To check before starting
1. Inspect the working area. Remove any
objects that could be thrown out.
2. Check the cutting attachment. Never use
blunt, cracked or damaged equipment
3. Check that the machine is in perfect
working order.
4. Check that all nuts and screws are tight.
1824 - 004 -