Husqvarna MADSAW 525iDEPS Powerhead Manual De Usuario página 26

2. Tighten the bar nuts by hand as tightly as
you can.
3. Lift the front of the guide bar and turn the
chain tensioning screw. Use a combination
wrench.
4. Tighten the saw chain until it is tight
against the guide bar but still can move
easily.
5. Tighten the bar nuts using the combination
wrench and lift the front of the guide bar at
the same time.
6. Make sure you can pull the saw chain
around freely by hand and that it does not
hang from the guide bar.
26
To fill with chain oil
1. Open the oil cap on top of the bar head.
2. Fill with Husqvarna saw chain oil.
3. Attach the cap again.
To check the chain lubrication
1. Start the product. Refer to
starting on page 16 .
2. Point the tip of the bar at a light surface.
3. Keep a distance of 20 cm (8 inches).
4. Operate the throttle at 75% for 1 minute.
5. Stop the product. Refer to
product on page 17 .
6. Make sure that you can see a line of oil on
the light surface.
CAUTION:
the guide bar if the saw chain
lubrication does not operate
correctly. Refer to
check of the guide bar on
page 22 for instructions. Speak
to your servicing dealer if the
maintenance steps does not
help.
To adjust the chain lubrication
WARNING:
before you make adjustments to the
oil pump.
To check before
To stop the
Do a check of
To do a
Stop the engine
1824 - 004 -