To Assemble The Shaft - Husqvarna MADSAW 525iDEPS Powerhead Manual De Usuario

3. Make sure that the edges of the cutting
links are facing forward on the top edge of
the guide bar.
4. Fit the cover and locate the chain adjuster
pin (A) in the hole in the bar. Check that
the drive links of the chain fit correctly on
the drive sprocket (B) and that the chain
is in the groove in the bar (C). Tighten the
bar nut finger-tight.
A
5. Tension the chain by turning the chain
tensioning screw clockwise using the
combination spanner. The chain should be
tensioned until it does not sag from the
underside of the bar.
6. The chain is correctly tensioned when it
does not sag from the underside of the bar,
but can still be turned easily by hand. Hold
up the bar tip and tighten the bar nuts with
the combination spanner.
14
7. When fitting a new chain, the chain tension
has to be checked frequently until the
chain is run-in. Check the chain tension
regularly. A correctly tensioned chain
ensures good cutting performance and
long life.

To assemble the shaft

1. Select the applicable shaft for your
operation.
2. Turn the knob to loosen the coupling.
B
3. Push and hold the release button.
4. Carefully push the shaft into the coupling
until you hear a click. Make sure that
the release button go into the hole in the
coupling.
1824 - 004 -