To Use The Product - Husqvarna MADSAW 525iDEPS Powerhead Manual De Usuario

To use the correct chain oil
WARNING:
oil, which can cause injury to you
and the environment. Waste oil also
causes damage to the oil pump, the
guide bar and the saw chain.
WARNING:
break if the lubrication of the cutting
equipment is not sufficient. Risk
of serious injury or death to the
operator.
WARNING:
chain oil for this function to operate
correctly. Speak to your servicing
dealer when you select your chain
oil.
Note:
This product has an automatic chain
lubrication system. You can also adjust the oil
To adjust the chain lubrication
flow. Refer to
on page 26 .
• Use only Husqvarna dielectric chain oil.
CAUTION:
below 0°C/32°F some chain oils
become too thick, which can
cause damage to the oil pump
components.
• Use the recommended cutting equipment.
Recommended cutting equipment
Refer to
on page 30 .

To use the product

• Hold the product as close to your body
as possible to get the best balance. Use
the harness to support the weight of the
machine and make it easier to handle.
• Make sure that the tip does not touch the
ground.
• Do not rush the work, but work steadily
until all the branches have been cut back
cleanly.
• Always work at full throttle.
18
Do not use waste
The saw chain can
Use the correct
In temperatures
• Whenever possible position yourself so
that you can make the cut at right angles to
the branch.
• Do not work with the shaft held straight
out in front of you as this increases the
apparent weight of the cutting attachment.
• Cut large branches in sections so that you
have better control over where they fall.
• Never cut through the swelling at the root
of the branch as this will slow down healing
and increase the risk of fungal attack.
1824 - 004 -