English / USA
:
Turn the guard in the direction of the
arrow until the adjusting lever points
downwards.
28
4
4
5
4
To relax the V-belt,
:
Unscrew the hexagon bolts (4) and
:
turn the tensioning nut (5)
counterclockwise with the
combination wrench –
approx. 1/4 turn, until it reaches "0".
:
Remove the hexagon bolts.
6
7
:
Pull the V-belt guard (6) off to the
front and remove the V-belt from the
front belt pulley.
:
Remove the bearing (7) with guard.
7
:
Fit the bearing (7) with guard on the
outboard side of the cast arm,
guiding the V-belt over the belt
pulley at the same time.
:
Refit the V-belt guard.
:
Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
:
Screw in the hexagon bolts, but do
not tighten them yet.
:
Refit the water attachment parts to
the guard.
Continue as described in the chapter
"Tensioning the V-belt".
TS 700, TS 800