Stihl TS 700 Cutquik Manual De Instrucciones página 10

Select bare ground for fueling and move
at least 10 feet (3 m) from the fueling
spot before starting the engine. Wipe off
any spilled fuel before starting your
machine.
!
Warning!
Check for fuel leakage while refueling
and during operation. If fuel leakage is
found, do not start or run the engine until
the leak is fixed and any spilled fuel has
been wiped away. Take care not to get
fuel on your clothing. If this happens,
change your clothing immediately.
!
Warning!
If fuel gets spilled on clothes, especially
trousers, it is very important to change
clothes immediately. Do not rely upon
evaporation. Flammable quantities of
fuel may remain on clothes after a spill
for longer than expected. Cutting metal
with a cut-off machine when clothes are
wet or damp from gasoline is extremely
dangerous, as the operator's clothes
might catch fire and cause serious or
fatal injury.
!
Warning!
An improperly tightened fuel cap can
loosen or come off and spill quantities of
fuel.
TS 700, TS 800
Different cut-off machines may be
equipped with different fuel filler caps:
Bayonet filler cap
Never use a tool to open or close the
bayonet filler cap, as this could damage
the cap and cause fuel to leak out.
The bayonet filler cap must be closed
with care after refuelling.
Fuel filler cap with screw thread
Secure the fuel filler cap
as tightly as possible after
refuelling.
This reduces the risk of the cap working
loose due to engine vibrations and fuel
leaking out.
English / USA
!
Warning!
Never attempt to force the cap open by
using a tool. It may damage the cap and
allow fuel to leak.
Before use, make sure that the fuel cap
has been properly tightened and any
spilled fuel wiped away. Check for fuel
leakage while refueling and during
operation. If a fuel leak is suspected, do
not start or run the engine until the leak
is fixed and spilled fuel has been wiped
away.
9