Stihl TS 700 Cutquik Manual De Instrucciones página 43

English / USA
Tensioning the rewind spring
: Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
: Hold the rope rotor tight:
pull out the twisted rope and
untangle it.
: Release the rope rotor.
: Slowly let go of rope so that it winds
onto the rotor.
The starter grip must be drawn firmly
into the rope guide bush. If it tips
sideways: increase the spring tension by
another turn.
42
: It must be possible to turn the rope
rotor on another half-turn when the
rope has been drawn out
completely.
If not, the spring has been tensioned
too tightly and may break. Remove
one turn of the rope from the rotor.
: Refit the starter cover.
: Press the remaining rope into the
handle.
Replacing a broken rewind spring
: Remove the rope rotor as described
for "Replacing the starter rope".
7
7
: Remove the screws (7).
: Remove the spring housing and
spring parts.
: Fit a new spring housing with the
bottom upwards.
: Turn in the screws.
: Refit the rope rotor.
: Tension the rewind spring
: Refit the starter cover and screw it
into place.
: Fit the hose in the guide in the
starter cover
If the spring has popped out of the
spring housing:
: Refit it, working anticlockwise from
the outside inwards.
TS 700, TS 800