ENGLISH
4. PRODUCT ASSEMBLY
Unfold
Pull up the stem while pressing down the rear fender.
Raise the stem, place the folding tab in a close position and turn the fixing ring to hold the tab.
Fig. 25
Fix the brake with an M6 hex wrench.
Paying attention to the rotation direction, tighten the handlebar.
Fig. 26
Fold
Turn the fixing ring to loosen it.
Open the folding tab.
Fig. 27
Lower the folding tab and then the stem.
Align the closing hook with the gap on the rear fender and press it down to ensure it is locked.
Fig. 28
5. OPERATION
Buttons
Power switch: Long press this push push button to turn the scooter on or off.
Throttle: Use it to start the scooter up and to accelerate.
Brake: Hold it pressed to stop. Gently step on the rear fender to assist the braking process.
Function: Press this push button to adjust speed. Select between:
ECO mode: No icon is shown on the display.
COMFORT mode: The displays shows a white "D".
SPORT mode: The display shows a red "D".
Headlights: The back and front lights will always be on as long as the scooter is on. The back
light will blink when the device stops.
Cruise mode: Ride at steady speed for 6 seconds to enter this mode. To deactivate it, press the
throttle or brake.
Note: This mode is not activated in the default configuration.
Note: The back light will blink when using the brakes.
On-board computer operating:
The on-board computer offers the following functions:
P1: Selecting km/h or mph.
28
BONGO SERIE A