cecotec bongo A Serie Manual De Instrucciones página 30

ENGLISH
Fig. 34
Only get off the scooter when riding at very low speed or when it is stopped.
How to charge the scooter
Open the charge port cover. Make sure it is clean and dry.
Connect the charger with the battery and the other end to the power supply.
Check the battery indicator is on.
The light indicator on the charger will change when it reaches 100 % charge.
Fig. 35
Note: Once the colour has changed, stop charging it. If the battery is left to overcharge for long
time the battery service life can be affected.
Warning: Cover the charge port with the anti-dust cap to avoid any metallic element from
touching it to prevent short-circuits.
Charging method 1
Fig. 36
Charging method 2
Fig. 37
Use of the tyres
For a correct operation of the scooter, always check and maintain the correct pressure of your
tubeless tires.
The optimum tyre pressure is 50 PSI / 3.4 bar / 340 kPa.
If you are using the scooter for the first time, make sure the pressure is correct. We recommend
to check the pressure regularly to ensure that the pressure is on the recommended values for
efficient driving.
We recommend the use of a heat-sealed gel on the tyres to prevent punctures and maintaining
its effectiveness and features.
6. CLEANING AND MAINTENANCE
Make sure the robot is disconnected from the power plug and switched off before cleaning or
repairing it.
Use a soft cloth to clean the outside part of the scooter.
Do not immerse the scooter in water or other liquids to clean it. This could cause permanent
damage to its electronic parts.
Do not try to repair the appliance by yourself. If it presents any damage or fault, contact the
Technical Support Service of Cecotec.
30
BONGO SERIE A