GASPARDO PINTA Empleo Y Mantenimiento página 44

ENGLISH
OIL COOLING
When using a dependent system it is important to check the capacity
of the tractor's oil tank and whether the cooling system is sufficient.
If necessary have an oil cooler or a larger tank installed on the
tractor by the dealer: the ratio between the volume of oil in the
system and the capacity of the tank should be approximately 1:2.
- Always keep oils and grease out of reach of children.
- Always read warnings and precautions indicated on the
containers carefully.
- Avoid skin-contact.
- After use wash the equipment thoroughly.
- Treat the used oils and polluting liquids in conformity with the
laws in force.
The Manufacturer declines all responsibility due to negligence
and non-observance of these rules.
3.6 ADJUSTING THE SEEDING DEPTH
To obtain a good level at which sprouts come out, the seed needs
to be placed at the right depth into the seeding bed.
The planting depth is adjusted individually for each element, by
using the nut (B) to regulate the compression springs (A, Fig.
27). Depending on the type of the type of soil, either increase or
decrease the compression of the spring in order to determine
the correct working depth.
With disc-type planter shoes, the depth is determined by the
limiter block (A Fig. 28) by changing its position with the lever (B
Fig. 28).
Coulters that work in the tracks of the seeder or the tractor
should be set to greater pressure.
3.7 SEED LEVEL IN THE HOPPER
The level of seed in the hopper can be easily controlled by the
operator from the driver's seat by checking the indicator (Fig. 29).
3.8 HOE ADJUSTMENT
The mounted wheels for track eradication eliminate the tracks
left by wheels (of the tractor or the planting unit). To adjust the
position of the mounted wheel track eradicator, unscrew the bolts
"A" (Fig. 30), position the mounted wheels and block the bolts. To
adjust the depth of the mounted wheels (max 3÷5 cm), unscrew
the nut "B" and the screw "C" (Fig. 30), after adjustment, block the
screw "C" and the nut "B".
44
ATTENTION
USE AND MAINTENANCE
fig. 27
fig. 28
B
A
fig. 29
A
fig. 30
g
B
A
+
-
C
B
cod. G19502491