Publicidad
10) to keep the seeder perpendicular to the ground (Fig. 11)
3) Block the movement of the parallels of the tractor on the
horizontal plane using the stabilizers provided, so eliminating
the side swaying of the equipment. Check that the tractor
hoisting arms are positioned at the same height from the
ground.
4) Adjust the height of the tractor lifting arms:
a) In the work position, adjust the path of the tractor hoisting
arms to guarantee adequate downward movement of the
planting unit. Otherwise, when hollows are encountered in
the seedbed, seed distribution could be irregular due to the
seed planting unit transmission wheels slipping (planing
effect).
b) in the transporting position, adjust the arms so that the
seeder does not, for any reason whatsoever, come into
contact with the ground.
5) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off. Check that the guard turns
freely and fix it with the chain provided.
6) The hydraulic pipes must be connected correctly to the tractor
distributors (see chapter 3.1) following the instructions on
each pipe (Fig. 12).
3.3 ADAPTING THE CARDAN SHAFT
The Cardan shaft, supplied with the machine, is of standard
length. It might, therefore, be necessary to adapt the cardan
shaft. Should this be the case, before proceeding, consult the
Manufacturer.
- When the Cardan shaft is with drawn to the end of its stroke,
the two pipes should ovelap by at least 15 cm (A Fig. 13).
When it is inserted all the way, the minimum admissible play
is 4 cm (B Fig. 13).
- When using the equipment on another tractor, check that
conditions are as stated above and check that the guards
complete ly cover the rotating parts of the Cardan shaft.
ATTENTION
For transportation of the seeder, always follow the
Manufacturer's instructions.
3.4 UNHOOKING THE SEED DRILL FROM THE TRACTOR
Unhooking the seed drill from the tractor is a very dangerous
operation. Great caution must be used and the whole operation
must be carried out following the instructions.
For a correct unhooking operation of the seed drill it is necessary
to proceed on a horizontal level.
1) Lower the supporting base elements
2) Slowly lower the seed drill until it rests completely on the
ground.
3) Unhook the Cardan shaft from the tractor and put it on the
special hook.
4) Loosen and unhook the third point, following the first and
second.
cod. G19502113
CAUTION
DANGER
USE AND MAINTENANCE
A
B
g
ENGLISH
cm 15 min
Max
cm 4 min
Min
fig. 11
fig. 12
fig. 13
47
Publicidad
