Publicidad
Idiomas disponibles
Idiomas disponibles
Climate class
Climate
Ambient temperature
range
of the room
Between +50˚F (10˚C)
SN
and +90˚F (32˚C)
Between +60˚F (16˚C)
N
and +90˚F (32˚C)
Between +60˚F (16˚C)
ST
and +110˚F (38˚C)
Between +60˚F (16˚C)
T
and +120˚F (43˚C)
Product weight:
Category
Product weight
Load bearing capacity of the doors
Max load
Fridge door
Freezer door
FBCD 761 TNF EDBL
FBCD 762 TNF EDBL
This appliance has
been designed
to be used in
certain climate
ranges (ambient
temperatures). It
must not be used
out of this range.
FBCD 761 TNF EDBL
FBCD 762 TNF EDBL
361Ibs (164kg)
FBCD 761 TNF EDBL
FBCD 762 TNF EDBL
55Ibs (25kg)
22Ibs (10kg)
Installation Place
You must follow the instructions below:
• The floor on which the product will be installed must be
capable of bearing 1,200 pounds (544 kg) minimum.
• Kitchen floor and the bottom of the product must be at the
same level. Otherwise, problems may occur with the air
suction of the product.
• There must be no objects preventing the installation of the
product at the back and on the side walls of the product's
installation place.
• The power socket must be at the correct place.
• Dimensions of the furniture where the product will be
installed must be in strict conformity with the dimensions
given in the manual.
• Do not install the product with the fridge and the freezer are
adherent next to each other. Otherwise, condensation and
damage may occur in the product. (Please see "Dual Cabin
Installation" for detailed information)
• Flatness of the floor where the product will be installed must
be checked with a Bubble Level Tool.
• Installation area must not be subjected to direct sunlight and
it must be away from heat sources, ovens, radiators etc.
• The ambient temperature must be between 55˚F (13˚C) and
110˚F (43˚C). Otherwise,
• function errors may arise when the product is running.
• If it is not possible to avoid installing the product near a
heat source, the minimum clearances given below must be
maintained between the product and the said source:
• 11/4" (3 cm) from electric hobs or ovens 1 1/4"
• 12" (30 cm) from gas or fuel operated hobs or ovens
Please observe the following rules:
• The power socket or fuse must be easily accessible in case
of an emergency; it must not be hidden behind the product.
• Plug or cable must not touch the back surface of the product.
Otherwise, it may get damaged due to the vibration of the
product.
• Do not connect the plugs of other appliances behind this
product. If the humidity level is high where the product is
used, corrosion may be seen on the outer surface of the
product. Keep the installation room dry and well-cleaned to
avoid corrosion.
To avoid the risk of electric shock:
• Connect the plug to a grounded 3-pin socket.
• Do not remove the ground terminal of the plug.
• Do not use adapters.
• Do not use extension cables.
EN
3
Publicidad
