Descargar Imprimir esta página

Fulgor Milano FBCD 761 TNF EDBL Instrucciones De Instalación página 48

Ocultar thumbs Ver también para FBCD 761 TNF EDBL:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 171
EN
ATTENTION
Failure to follow these instructions may result in death, fire or
electric shock. Connecting the grounding conductor of the
equipment to an improper place may lead to electric shock.
Please have the grounding checked by a qualified electrician
or service technician if you have any doubt about the proper
grounding of the product.
Installation, repair and other procedures performed by
unqualified persons may cause danger. Before installing
the appliance, make sure that the voltage, load and circuit
current parameters on the data plate are in compliance with
the power mains in your house.
The appliance is provided with a plug and power cable which
is ready to be connected to a 220-240V 50/60HZ power
supply. The appliance must be connected to a 3-pin socket.
The plug must be installed only by a licensed electrician.
If the electrical wiring or the electric power supply of the
house needs alteration, the necessary procedures must be
performed by a qualified electrician.
ATTENTION
Do not install your refrigerator:
• In open areas
• In environments where water is dripping
• In environments where temperature is lower than 55˚F
(0˚C)
Furniture:
Make sure that the furniture where you will install the appliance
has been safely mounted in your kitchen.
Your furniture must be connected to the floor and the wall
properly and with suitable connections.
For the best installation, clearances between the furniture and
the product must be in compliance with the values specified in
the installation instructions.
Side walls must be free of clearances and their surfaces must
be flat.
Minimum thickness of the side walls must be 5/8" (16 mm).
Minimum thickness of the doors to be attached to the product
must be 3/4" (19 mm) .
ATTENTION
There is a stainless steel door and stainless kick plate option.
Please consult the authorised service.
Ventilation:
Vent holes where the air enters and exits the unit must not be
blocked or obstructed. In addition, you must periodically clean
the dust and dirt that accumulate on these holes in time.
4
Electrical Connection:
• Never use an extension cable.
• The power socket must definitely be grounded and checked
by an authorised person.
• Location of the electrical wiring must comply with the
dimensions specified in the manual.
ATTENTION
RISK OF ELECTRIC SHOCK
Electrical grounding is necessary. This appliance is equipped
with a three-pin plug to protect you against possible electric
shocks.
• Do not remove the round grounding terminal from the plug.
• Do not use two-pin grounding adapters.
• Do not use extension cables to energise the product.
ATTENTION
Do not connect the grounding cable to the gas pipe. Please
have the grounding checked by a qualified electrician if you
are not sure about the grounding of the product. Do not install
a fuse on the neutral line or grounding circuit.
WARNING
Please wait for 3-6 hour before energising the product to
protect it against possible damages. This way, the refrigerant
and the lubricants in the system get balanced.
Water Connection
• Pressure of the mains water must be in compliance with the
values specified in the manual.
• Location of the water system must comply with the dimensions
specified in the manual.
IMPORTANT INFORMATION
Bypass is recommended for the water filtering system if a
reverse osmosis system is used.

Publicidad

loading

Este manual también es adecuado para:

Fbcd 762 tnf edbl