Publicidad
Idiomas disponibles
Idiomas disponibles
EN
WARNING
If you are not sure whether the existing connection parts are
fit to the wall as securely as they should be, you can use
alternative anti-tip methods.
If there is furniture at the back wall of the refrigerator, please
make sure that the furniture is fixed to the wall. For this, you
need to be sure that the back wall of the furniture is fixed to
the concrete back wall with suitable connection parts.
Alternative anti-tip method
If the anti-tip brackets cannot be connected securely, you must
use the alternative method below.
In this method, you can use wooden girders to avoid the risk
of tipping over.
It must be installed as illustrated in the figure below.
There must be no clearance between the product and the
wooden girder.
Minimum section dimensions of the wooden girder must be
3"x4" (75 mm x 100 mm). Width of the girder must be equal
to the clearance where it will be installed.
An additional girder must be used if the niche depth is more
than anticipated. The wooden girder must contact the product
with a maximum size of 2" (50.8 mm).
To determine the location for the wooden girder, mark it on the
rear wall, select suitable screws and connect safely.
WARNING
Number and features of the screws to be used for the wooden
girder must be determined so that there is no safe connection.
18
Preparing the Water Hose and the
Power Plug
You will need a hose with a minimum length of 60" (1.5
meters) and a diameter of 1/4" for water connections of the
product during installation.
A connector that has a thread with an external diameter of
1/4 must be used to connect the hose end to the product. You
can choose the method A or method B below to prevent the
cable from gettting jammed.
Method A: Locate the water hose
and power supply on the back
Method B: Locate the water hose
and power supply on the side
Publicidad
