Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Location of the Water System
The water connected to the water mains must be potable.
Location of the water system must be within the range given
below.
Water system of the refrigerator must be connected to the
water mains system in the house.
The user must be able to switch it on/off with the valve when
necessary.
Objects that might pierce the water hoses or cause them to
twist must not be present where the water line is installed.
Pressure of the water system must be between 25-80 psi (1.7-
5.5 Bar).
If the water pressure exceeds 80 psi, install a pressure limiting
device or water impact protector to the inlet valve.
Never install the product or operate the appliance if it is
possible for the water pressure to exceed 120 psi.
WARNING
Make sure that there is no water leakage when making the
water connections. Otherwise,
there will be water on the floor and the furniture will get
damaged.
You will need a hose with a minimum length of 60" (1.5
meters) and a diameter of 1/4" for water connections of the
product during installation.
A connector that has a thread with an external diameter of ¼
must be used to connect the hose end to the product.
Before completing the installation, make sure that water flows
and there is no water leakage.
8
• Flatness of the floor where the product will be installed
• Uprightness of the furniture flanges must be checked with
• If the flatness and uprightness of the product is not proper,
1/4" (6mm)
WARNING
must be checked with a Bubble Level Tool.
a Bubble Level Tool.
problems may arise with the installation.
Publicidad
