Diamond Blades For Dry Cutting; Diamond Blades For Wet Cutting; Toothed Blads; Transport And Storage - Husqvarna K6500 Manual De Instrucciones

Ocultar thumbs Ver también para K6500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Diamond blades for dry cutting

Although no water is required for cooling, dry cutting
blades must be cooled with air flow around the blades.
For this reason dry cutting blades are recommended
only for intermittent cutting. Every few seconds of
cutting the blade should be allowed to run free" with no
load to allow the air flow around the blade to dissipate
the heat.

Diamond blades for wet cutting

Wet cutting diamond blades must be used with water
to keep the blade core and segments cool during
sawing. Wet cutting blades should NOT be used dry.
Using wet cutting blades without water can cause
excessive heat build-up, resulting in poor
performance, severe blade damage and is a safety
hazard.
Water cooling cools the blade and increases its
service life while also reducing the formation of dust.

Toothed blads

WARNING! Never use toothed blades
!
such as wood cutting blades, circular
toothed blades, carbide tipped blades
etc. The risk of kickback is significantly
increased and tips can be torn off and
thrown at high speed. Carelessness can
result in serious personal injury or even
death.
Government regulation requires a
different type of guarding for carbide
tipped blades not available on power
cutters – a so called 360 degree guard.
Power Cutters (this saw) use Abrasive or
Diamond blades and have a different
guarding system which does not provide
protection against the dangers presented
by wood cutting blades.

Transport and storage

Do not store or transport the power cutter with the
cutting blade fitted. All blades should be removed from
the cutter after use and stored carefully.
Store cutting blades in dry, frost free conditions.
Special care should be taken with abrasive blades.
Abrasive blades must be stored on a flat, level surface.
If an abrasive blades is stored in humid conditions,
this can cause imbalance and result in injury.
Inspect new blades for transport or storage damage.
10 – English
CUTTING BLADES

Publicidad

Tabla de contenido
loading

Tabla de contenido