Sauder Lateral File 107302 Instrucciones De Montaje página 11

Step 7
Fasten the RIGHT END (A) to the TOP (C), LOWER BACK (E),
å
DRAWER MOLDING (H), and BRACE (N).
Tighten the TWIST-LOCK® FASTENERS in the RIGHT END (A),
å
LOWER BACK (E), DRAWER MOLDING (H), and BRACE (N).
Fasten three ANGLE BRACKETS (Y) to the BRACE (N) exactly
å
as shown. Use three 9/16" LARGE HEAD SCREWS (HH) through
the BRACKETS and into the pre-drilled holes in the BRACE.
NOTE: Be sure the edge of each BRACKET is even with
å
the edge of the BRACE.
Fasten the FRONT SKIRT (G) to the ANGLE BRACKETS
å
on the BRACE (N).
NOTE: Do not overtighten the SCREWS.
å
Y
www.sauder.com/services
Rounded edge
G
N
E
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
C
H
A
107302
HH
Page 11