Sauder Lateral File 107302 Instrucciones De Montaje página 8

Step 4
Separate the EXTENSION SLIDES (Q) from the
å
EXTENSION RAILS (P) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (P) to the ENDS (A and B).
å
Use eight GOLD 7/16" FLAT HEAD SCREWS (KK).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into
this hole.
KK
GOLD 7/16" FLAT HEAD SCREW
(8 used in this step)
P
Open end
Open end
Rounded edge
Page 8
Push down the black lever and pull the SLIDE from the RAIL.
Q
B
P
P
P
A
107302
Just think. The sooner
you do this, the sooner
you do something else.
Open end
Open end
P
Rounded edge
Use this hole.
www.sauder.com/services