Descargar Imprimir esta página

Nilfisk Advance SW4000 Instrucciones De Uso página 29

Ocultar thumbs Ver también para Advance SW4000:

Publicidad

Idiomas disponibles

Idiomas disponibles

PANEL DUST FILTER CLEANING AND INTEGRITY CHECK
Method "A"
Method "B"
03/2013
WARNING!
Wear appropriate dust mask to avoid
breathing in dust.
1.
Drive the machine on a level ground, engage the parking
brake and turn the ignition key (61) to "0".
2.
Open the battery compartment hood (18) with the handle
(41) and fasten it with the support rod (52), then disconnect
the battery connector (45).
3.
Disconnect the vacuum system motor connector (53).
4.
Release the fasteners (A, Fig. 13) and remove the vacuum
system cover (B).
5.
shaker assembly (D).
6.
7.
8.
surface (with the dirty side down) to remove dust and dirt.
NOTE
Take care not to damage the metal lip which extends
past the gasket.
CAUTION!
clean it, otherwise it can be damaged.
for 15 minutes, then rinse it under a gentle stream of water
installing it back into the machine.
and non-lathering detergents.
This provides better quality cleaning but reduces the life of the
9.
following:
(G, Fig. 14) upwards).
replaced.
The dust filter must be regularly cleaned to maintain the
efficiency of the vacuum system. Follow the recommended filter
service intervals for the longest filter life.
Wear safety glasses when cleaning the filter.
Do not puncture the filter.
Clean the filter in a well-ventilated area.
Unscrew the knobs (C, Fig. 14) and remove the filter
Fasten the filter shaker assembly to the holder (E).
Lift the dust filter (F) and remove it from the machine.
Clean the filter using one of the methods below:
Collect dust from the filter. Gently tap the filter against a flat
Collect dust from the filter. Blow compressed air (maximum
pressure 6 Bar) into the clean side of the filter (in the opposite
direction of the airflow).
Method "C" (only for polyester dust filter)
For paper filter: Do not use water or detergents to
Collect dust from the filter. Then soak the filter in warm water
(maximum pressure 2.5 Bar). Let the filter dry completely before
For a better cleaning, it is allowed to wash the filter with water
filter, which will have to be replaced more frequently. The use of
inadequate detergents can damage the filter.
Install the filter in the reverse order of removal and note the
Clean the filter housing.
Install the filter with the strainer facing upwards (arrow
If the filter gasket is damaged or missing, it must be
INSTRUCTIONS FOR USE
1464818000 - SW4000
Figure 13
Figure 14
A
B
A
D
C
C
F
ENGLISH
P100600
P100601
A
A
C
E
G
C
27

Publicidad

loading