Descargar Imprimir esta página

Nilfisk Advance SW4000 Instrucciones De Uso página 30

Ocultar thumbs Ver también para Advance SW4000:

Publicidad

Idiomas disponibles

Idiomas disponibles

SKIRT HEIGHT AND OPERATION CHECK
ENGLISH
Preliminary Operations
Side Skirt Check
Front and Rear Skirt Check
Reassembly
28
1.
Empty the hopper (as shown in Use chapter), because the
weight of the waste inside the hopper can affect the skirt
height check.
2.
Drive the machine on a level ground that is suitable for
checking the skirt height.
3.
Turn the ignition key (61) to "0" and engage the parking
brake.
4.
Remove the left and right doors (13 and 12) by turning the
fasteners.
5.
Check the side skirts (A, Fig. 15) for integrity.
Replace the skirts when they have cuts (C, Fig. 16) larger
than 20 mm or cracks/tears (D) larger than 0.4 in (10 mm)
(for skirt replacement, refer to the Service Manual).
6.
Fig. 15) is within 0 - 0.12 in (0 - 3 mm) (Fig. 17).
If necessary, loosen the knobs (B, Fig. 15) and adjust the
skirt position. Then tighten the knobs (B).
7.
Remove the main broom as shown in the relevant
paragraph.
8.
Check the front skirt (E, Fig. 18) and rear skirts (F) and (G)
for integrity.
Replace the skirts when they have cuts (C, Fig. 16) larger
than 0.8 in (20 mm) or cracks/tears (D) larger than 10 mm.
9.
Check that the front (E, Fig. 18) and rear skirt (G) slightly
rub ground without being detached from it (Fig. 19).
10. For the skirt replacement, see the Service Manual.
11. Assemble the components in the reverse order of
disassembly.
Check that the distance from the floor of the side skirts (A,
INSTRUCTIONS FOR USE
SW4000 - 1464818000
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
B
> 10 mm
> 20 mm
(> 0,4 in)
(> 0,8 in)
D
0÷3 mm
(0÷0,12 in)
E
03/2013
P100602
P100603
P100604
P100605
P100606
A
B
C
F
G

Publicidad

loading