Descargar Imprimir esta página

Nilfisk Advance SW4000 Instrucciones De Uso página 31

Ocultar thumbs Ver también para Advance SW4000:

Publicidad

Idiomas disponibles

Idiomas disponibles

DUSTGUARD™ SYSTEM WATER FILTER CLEANING (OPTIONAL)
HOPPER HYDRAULIC LIFTING SYSTEM OIL LEVEL CHECK
03/2013
NOTE
system tank (24).
1.
Drive the machine on a level ground.
2.
Turn the ignition key (61) to "0" and engage the parking
brake.
3.
assembly (B) of the dust guard system.
4.
Unscrew and remove the transparent cover (C) with the
5.
Clean and install them on the holder (F).
NOTE
holder.
WARNING!
fully retracted.
1.
Turn the ignition key (61) to "0" and engage the parking
brake.
2.
Open the battery compartment hood (18) with the handle
(41) and fasten it with the support rod (52).
3.
Check that the oil level in the tank (51) is between the
minimum (MIN) and maximum (MAX) marks shown in
4.
If necessary, add oil through the plug (A, Fig. 21), using the
5.
Remove the support rod (52) and close the hood (18).
To prevent water from flowing out when cleaning the
filter, turn on the dust guard system and empty the
From under the machine (A, Fig. 20), reach the water filter
gasket (D), then remove the filter strainer (E).
Install the gasket (C) and the filter strainer (E) in
the housings of the cover and of the filter assembly
Procedure to be performed with the hopper (11)
figure 21.
oil specified in Technical Data paragraph.
INSTRUCTIONS FOR USE
1464818000 - SW4000
Figure 20
Figure 21
A
B
ENGLISH
29
P100651
P100607
F
D
E
C

Publicidad

loading