Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
03/2013
(*)
Procedure to be performed by Advance Service Center.
For further information, refer to the Service Manual, available at any Advance Service Center.
Trouble
The machine operates only when stationary,
otherwise it turns off and the red warning
The battery autonomy is low.
When turning the ignition key (61) to "II", the
display does not turn on and the machine
does not operate.
The machine does not move when pressing
the drive pedal and the warning light (78)
The main broom does not work and the
The side brooms do not operate.
The machine collects little debris/dust.
The hopper does not lift.
The hopper does not dump.
The hopper does not lower.
The dust guard system (optional) does not
work.
light (73) flashes.
flashes.
warning light (77) flashes.
The filter shaker does not operate.
INSTRUCTIONS FOR USE
Possible cause
The batteries are discharged.
The battery connector is disconnected.
The F3 and/or F0 fuse is open.
The emergency push-button has been
pressed.
The drive pedal has been pressed while
turning the ignition key (61) to "II".
Drive system failure.
The safety system has activated.
The FA fuse is open.
The FR1 or FR2 circuit breaker of the side
brooms is open.
The hopper is full.
The skirts are not properly adjusted or are
broken.
The brooms are not properly adjusted.
The F1 fuse is open.
The hydraulic system oil level is incorrect.
The F6 fuse is open.
The hopper is too low.
In case of low temperatures, the hydraulic
valve.
The F2 fuse is open.
The water tank is empty.
The pump is faulty.
The F5 fuse is open.
The batteries are no more efficient.
The dust filter is clogged.
system oil is slow in flowing through the safety
The filter shaker is disconnected.
The nozzles or the water filter are clogged.
1464818000 - SW4000
Charge the batteries.
If the trouble persists, replace the batteries.
Replace the batteries. If necessary, install
batteries with higher capacity (see Technical
Data paragraph).
Connect the battery connector.
Check/replace the fuses.
Check and release the emergency push-
button.
Turn the ignition key to "0", then restart without
pressing the drive pedal.
Turn off the machine and then turn it on again.
If the trouble persists, contact the Service
Center.
Turn off the machine and then turn it on again.
Check the condition of the main broom (debris
that slows down the broom or excessive
pressure on the ground).
Wait for the main broom motor to cool down,
then replace the fuse.
Wait for the side broom motor to cool down,
then reset the fuse by pressing the relevant
push-button.
or by disassembling it.
Empty the hopper.
Adjust/replace the skirts.
Adjust the broom height.
Replace the fuse.
Check the hydraulic system oil level in the
tank.
Replace the fuse.
Lift the hopper at a minimum height of 350
mm.
Wait a few moments to let the hydraulic
Replace the fuse.
Fill the tank.
Clean.
Replace. (*)
Replace the fuse.
Clean the dust filter by using the filter shaker
system oil flow.
Connect the filter shaker connector.
ENGLISH
31
Remedy
Publicidad
