Heiniger SIRIUS Manual De Instrucciones página 35

6.2.5 Battery clip
2
Fig. 26
Fig. 27
NOTE!
If not used on a daily basis, store the clipper and charging station in the supplied pack-
aging. If you do use the clippers on a daily basis, we recommend storing the clipper or
reserve battery in the charging station.
7 Troubleshooting
y The here described tasks for troubleshooting can be done mostly by the operator.
y Some tasks may only be done by especially trained personal or by an authorised service
centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts poorly or
not at all
No speed difference
between level I and
level II
Translation of the original instructions / Hair clippers
The battery clip is for storage of the second battery. The
battery clip (1) clicks into the charging station (2). Use of
1
the battery clip is optional.
1. Insert the battery as shown, with the contacts facing
downwards. Either insertion orientation can be used.
Cause
Clipper head is not well
engaged
Turning lever is defective
The top and bottom blades
stick to each other
Clipper blades are blunt
Clipper blades have not
been correctly ground as per
specification
Clipper blades are not oiled
Hairs jammed between top
and bottom blades
Clipper head has too little
clipping pressure
Faulty motor and / or electron-
ics
Rectification
Engage the clipper head correctly
when the motor is running
Replace turning lever (S)
Clean and oil the blades
Have top and bottom blades resharp-
enend by service centre (S)
Oil clipper blades every 15 minutes
Take off clipper head, push the top
blade half away from the clipper
head, take away hairs between top
and bottom blade
Have clipper head inspected (S)
Notify customer service
17