Publicidad
Idiomas disponibles
Idiomas disponibles
► Pull the chain [2-3] over the chain sprock
et [2-8] and remove it together with the
guide strip [2-4].
► Place the new chain [2-3] on the (new)
guide strip [2-4] and insert it into the saw.
Ensure that the chain teeth are in the
correct position relative to the direc
tion of rotation.
The direction of rotation is marked on
the saw by an arrow. There is also a
marking under the chain sprocket cov
er [2-1] showing how the chain should
be inserted.
► Insert the guide links of the chain precisely
into the chain sprocket teeth [2-8], turn us
ing the tensioning wheel [2-9] so that the
opening for clamping bolt [2-5] engages on
the clamping bolt [2-6].
–
Clockwise to loosen: As viewed from
above, the screw moves upwards.
–
Anticlockwise to tighten: As viewed
from above, the screw moves down
wards.
► Then place the chain sprocket cov
er [2-1] on the retaining screw [2-7] and
tighten it by turning the tensioning
wheel [2-2] clockwise.
The chain must be tensioned correctly
before being tightened.
11.7 Replacing the chain sprocket
► Remove the chain with the guide strip (see
section 11.6).
► Use a screwdriver to remove the safety
bracket clamp [8-1] from the spin
dle [8-4] and to remove the washer [8-2]
and the chain sprocket [8-3].
► After the replacement, reinsert the chain
sprocket, washer and locking mechanism.
11.8 Lubrication and cleaning
We recommend that you clean the power tool
regularly. Keep the power tool free from dust,
chips, resin and other impurities.
Using solvent-based cleaning agents may dam
age the painted surfaces or plastic parts. If
these cleaning agents are used, we recommend
that you test their effect on a small, concealed
area.
During each sharpening process or when re
placing the cutting tool set, dust and chips must
be removed from the inside of the cover, and
the guide slot, the lubrication openings and the
blade's clamping surfaces must be cleaned.
The air holes on the motor cover must not be
blocked.
11.9 Replacing the carbon brushes
Commission an authorised workshop to
–
change brushes, the power cable, etc. If
the power tool suffers an impact, it is also
necessary to use an authorised workshop
in order to prevent any mechanical or elec
trical hazards.
–
The carbon brushes are checked after ap
prox. 200 operating hours. The carbon
brushes are accessible after removing the
cover. If the carbon brushes are shorter
than 5 mm, they must be replaced.
–
The power tool is equipped with self-de
taching carbon brushes that come off auto
matically once the minimum length is
reached. Only original carbon brushes
should be used.
12 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac
cessories and packaging. Observe appli
cable national regulations.
In accordance with the European Directive on
waste electrical and electronic equipment and
implementation in national law, used power
tools must be collected separately and handed
in for environmentally friendly recycling.
Information on collection points for proper dis
posal can be found at
recycling.
Information on REACH:
reach
English
www.festool.co.uk/
www.festool.co.uk/
33
Publicidad
