Festool IS 330 EB Instrucciones De Uso página 27

it reaches the maximum speed, controlled by
the electronic control unit. The electronics pro­
tect the motor. The motor is switched off auto­
matically if it experiences sudden overload. If
overloaded for a longer period, it switches to
"cooling mode", during which the power tool
runs at a low cooling speed and, once cooled, it
returns to the normal operating mode. When
the power tool is switched off, the electronic
brake is activated at the same time, which sig­
nificantly shortens the chain run-on time. The
run-on time may vary greatly depending on the
set speed.
3.2 Tool properties
The insulation saw is designed to saw insulating
materials.
The power tool is operated by one person who
holds and guides it by the handles provided, i.e.
at the front additional hand grip and at the rear
handle. Holding the power tool at the rear addi­
tional hand grip is only permitted if there is no
risk of kickback. Any other use of this power
tool is regarded as improper use.
The power tool is not intended for sawing wood,
for felling trees or for cutting trees and bushes.
The manufacturer of the power tool is not liable
for damage resulting from failure to comply
with the intended use. The user of the power
tool alone is responsible for the risks arising
from this type of use. Intended use also in­
cludes adhering to the operating, service and
repair conditions stipulated by the manufactur­
er. People under the age of 16 must not use this
power tool.
The user is liable for improper or non-in­
tended use.
4 Technical data
Insulation saw
Power supply
Mains frequency
Power consumption
Movable supply line
Fuse
Speed preselection
Stabilising electronics
Electric safety brake
Starting current limiter
5
IS 330 EB
220–240 V
50–60 Hz
1600 W
H07RN-F
15–16 A current
protection
o
o
o
o
Insulation saw
Automatic lubrication of the
guide strip
Chain sprocket rotation de­
pending on setting of elec­
tronics
Max. chain speed
Mitre cut
Cutting depth [33 cm (13") guide strip]
At 0°
At 15°
At 30°
At 45°
At 60°
Oil reservoir capacity
Weight as per EPTA proce­
dure 01:2014
Parts of the machine
[1-1] Safety lock
[1-2]
Handle
[1-3] Switch button
[1-4] Offset parallel side fence
[1-5]
Chain guard
[1-6] Clamping screw for parallel side
fence
[1-7] Guide table
[1-8] Front additional hand grip
[1-9]
Oil level indicator
[1-10] Oil reservoir cap
[1-11] Rotating chip ejector
[1-12] Chain tensioning wheel
[1-13] Oil feed wheel
[1-14] Setting for drawing cut
[1-15] Speed preselection
[1-16] Rear additional hand grip
[1-17] Offset parallel side fence
[2-1]
Chain sprocket cover
[2-2] Tensioning wheel
[2-3] Chain
English
IS 330 EB
o
2200–4600 rpm
12 m/s
0°–60°
330 mm
315 mm
285 mm
230 mm
165 mm
~ 240 ml
7.0 kg
27