Publicidad
Idiomas disponibles
Idiomas disponibles
Starting up the blower
Make sure that there are no children or other people within
1.
a working range of 15 meters, also pay attention to any ani-
mals near by.
Before operating, always check that the blower is safe for
2.
operation:
Check the security of the throttle lever. The throttle
—
lever should be checked for smooth and easy action.
Check for proper functioning of the throttle lever lock.
—
Check for clean and dry handles and test the function of
—
the l-O switch. Keep handles free of oil and fuel.
Start the blower only in accordance with the instructions.
3.
Do not use any other methods for starting the engine.
Use the blower and the tools supplied only for applications
4.
specified.
Start the blower engine only after the entire tool has been
5.
assembled. Operation of the tool is permitted only after all
the appropriate accessories are attached.
The engine is to be switched off immediately if there are any
6.
engine problems.
When working with the blower, always wrap your fingers
7.
tightly around the handle, keeping the control handle cra-
dled between your thumb and forefinger. Keep your hand
in this position to have your machine under control at all
times. Make sure your control handle is in good condition
and free of moisture, pitch, oil or grease.
Always ensure a safe, well-balanced footing.
8.
Carry the blower properly on both shoulders during opera-
9.
tion. Do not carry the blower with only one shoulder strap.
Otherwise personal injury may result.
10. Operate the blower in such a manner as to avoid inhalation
of the exhaust gases. Never run the engine in enclosed
rooms (risk of suffocation and gas poisoning). Carbon mon-
oxide is an odorless gas. Always ensure there is adequate
ventilation.
11. Stop the engine when resting or leaving the blower unat-
tended. Place it in a safe location prevent danger to others,
setting fire to combustible materials, or damage to the
machine.
12. Never lay the hot blower onto dry grass or onto any com-
bustible materials.
13. All protective parts and guards supplied with the machine
must be used during operation.
14. Never operate the engine with a faulty exhaust muffler.
Transport
Stop the engine during transport.
1.
Position the blower safely during car or truck transportation
2.
to avoid fuel leakage.
When transporting the blower, ensure that the fuel tank is
3.
completely empty.
Lift the blower with holding carry handle when you carry it.
4.
Do not drag the blower by nozzle, pipe or other parts.
Hold the blower firmly during transportation.
5.
When transport the blower, bend your knee and make sure
6.
you do not damage your shoulder and lower back.
Refuelling
Stop the engine during refuelling, keep well away from open
1.
flame and do not smoke.
Avoid skin contact with petroleum products. Do not inhale
2.
fuel vapor. Always wear protective gloves during refuelling.
Change and clean protective clothing at regular intervals.
Take care not to spill either fuel or oil in order to prevent soil
3.
contamination (environmental protection). Clean the blower
immediately after fuel has been spilt. Allow wet cloths to dry
before disposing in properly, covered container to prevent
spontaneous combustion.
Avoid any fuel contact with your clothing. Change your
4.
clothing immediately if fuel has been spilled on it (fire
hazard).
Inspect the fuel cap at regular intervals making sure that it
5.
stays securely fastened.
Carefully tighten the fuel cap. Change locations to start
6.
the engine (at least 3 meters (10 ft) away from the place of
refuelling).
4 ENGLISH
Publicidad
