Dolmar PB-7660.4 Manual De Instrucciones página 7

ASSEMBLY
Before performing any work on the blower,
CAUTION:
always stop the engine and pull the spark plug cap off the
spark plug.
Start the blower only after having assembled it
CAUTION:
completely.
Always wear protective gloves.
CAUTION:
Assembling blower pipes
Insert the swivel pipe into the flexible pipe and tighten them with
1.
the hose band.
2
► 1. Swivel pipe 2. Flexible pipe 3. Hose band
Loosen and remove the clamp screw.
2.
► 1. Clamp screw
Install the control handle / handle assembly onto the swivel pipe
3.
and tighten them with the clamp screw.
► 1. Control handle / handle assembly 2. Clamp screw
3
1
1
1
2
Attach the flexible pipe to the elbow
4.
For tube throttle model: Insert the elbow to the flexible pipe. Attach
the cable holder between the hose band and the flexible pipe. Tighten
the cable holder, flexible pipe and elbow with the hose band. Set the
control cable onto the cable holder, and close the cable holder.
1
► 1. Elbow 2. Cable holder 3. Hose band
► 1. Cable holder 2. Control cable
For hip throttle model: Insert the elbow to the flexible pipe. Tighten
the flexible pipe and the elbow with the hose band.
Attach the long/short pipe to the swivel pipe. Turn the long/short
5.
pipe clockwise to lock it into place. Then attach the blower nozzle with
the long/short pipe. Turn the blower nozzle clockwise to lock it into
place.
1
► 1. Long/short pipe 2. Blower nozzle
Make sure all clamps are tight.
6.
7 ENGLISH
3
2
1
2
2