Keysight U1251B Guia Del Usuario página 170

6 Performance Tests and Calibration
Adjustment Procedure
Review the sections
Consideration"
1 Turn the rotary switch to "Test Function" position as shown in the adjustment
2 After unsecuring the instrument, the instrument goes into the adjustment
The instrument will be in the adjustment mode, unless you press Shift and
NOTE
3 The primary display will show the reference value of the Cal Item.
4 Configure each Cal Item.
5 Use the
6 Apply the input signal shown in the Input column of the table. The bar graph
Always complete the tests in the same order as shown in the appropriate table.
NOTE
7 Enter the actual applied input (see
8 Press
168
"Test Considerations"
on page 166 before proceeding with this procedure.
table.
mode (See "Unsecuring the instrument for calibration"
simultaneously to exit the adjustment mode.
and the
will display the Input reading. There is no bar graph display for temperature
adjustment.
page 165).
to start the adjustment. The CAL flashes in the secondary display
to indicate that the calibration is in progress.
on page 152 and
arrow keys to select the Cal Range.
"Entering Adjustment Values"
Keysight U1251B and U1252B User's and Service Guide
"Adjustments
on page 161).
on