Keysight U1251B Guia Del Usuario página 80

3 Functions and Features
Dynamic Recording
The Dynamic Recording mode can be used to detect intermittent turn-on or
turn-off voltage, current surges or to verify measurement performance without
you being present during the process. While the readings are being recorded, you
are free to perform other tasks.
The average reading is useful for smoothing out unstable inputs, estimating the
percentage of time a circuit is operating and verifying circuit performance. The
elapsed time is shown on the secondary display. The maximum time is 99999
seconds. When this maximum time is exceeded "OL" is shown on the display.
1 Press
2 Press
3 Press
NOTE – Press
– The average value is the true average of all the measured values taken in the
78
for more than 1 second to enter Dynamic Recording mode. The
meter is now in continuous mode or non-data hold (non-trigger) mode.
"MAXMINAVG" and present value of measurement are displayed. The
multimeter will beep when a new maximum or minimum value is recorded.
to cycle through maximum, minimum, average, and present
readings. The MAX, MIN, AVG, and MAXMINAVG indicators light up,
corresponding to the displayed readings.
or
mode.
to restart the dynamic recording.
Dynamic Recording mode. If an overload is recorded, the averaging function
will stop and the average value becomes "OL" (overload).
Dynamic Recording mode.
for more than 1 second to exit Dynamic Recording
Keysight U1251B and U1252B User's and Service Guide
is disabled in