Amprobe WT-20 Manual De Uso página 20

Parameter: TDS
"- - -" Meter is in manual range 1 however the
measured value is higher than 1999*TDS factor
ppm
• Press "p" more than 2 seconds to change
the range to range 2 or to auto ranging.
"E04" Caused by temp. or conductivity error
• Refer to error code of temp. After solving
the error of temp. & conductivity, E04 will
disappear.
Parameter: Temperature
"E01" Temperature circuit is damaged
• Send back for repair
"E02" Temp value is lower than range limit (0°C) or
temp. circuit is damaged
• Put the meter in room temp. for 5 mins. If
E02 still appears, send back for repair.
"E03" Temp value is higher than range limit (50°C)
or temperature circuit is damaged
• Put the meter in room temp. for 5 mins. If
E02 still appears, send back for repair
14