Beem ESPRESSO-GRIND-EXPERT Manual De Instrucciones página 44

EN
Before Initial Use
1. Wipe the device with a clean, damp cloth. Clean all accessories with a little detergent and clear
water.
2. When the device is delivered, the water pipe is 昀椀tted with transport protection that needs
to be removed. Pull the water tank (6) vertically up out of the device. On the water feed on
the device there is an orange plug – pull it out. The water tank can now be 昀椀lled and inserted
into the device.
3. Set up the device and connect it (see the "Setting Up and Connecting the Device" chapter).
4. Before you enjoy your 昀椀rst espresso or coffee, we recommend that you carry out a trial
run with espresso beans to remove any possible production residues in the grinder and in
the water system. To do this, follow the instructions in the "Operation and Functions" and
" Preparation" chapters.
When the device is 昀椀rst used, production-related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
5. Repeat this process twice. Do not drink this espresso!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
Setting Up and Connecting the Device
PLEASE NOTE!
Only connect the device to a plug socket that is properly installed. The plug socket must
•
also be readily accessible after connection so that the connection to the mains can quickly
be isolated. The mains voltage must match the technical data of the device.
Lay the connecting cable in such a way that it does not become squashed or bent and
•
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
Do not use the device in conjunction with extension cables.
•
Always set up the device with a clear space at the sides (at least 20 cm) and clear space
•
above it (at least 29 cm) on a 昀氀at, solid and heat-resistant surface that is resistant to
splashing.
Do not place the device below kitchen wall units or similar cupboards. The rising
•
steam could cause damage to them!
1. Place the device on the kitchen unit or another dry, clean work surface, following the safety
notices and the notices provided at the beginning of this chapter.
2. Plug the mains plug into a plug socket. The 昀椀eld
The device is in standby mode.
(35) lights up and a beep is heard.
44