Publicidad
Idiomas disponibles
Idiomas disponibles
EN
The operating 昀椀elds are simultaneously control lamps which indicate by 昀氀ashing or being lit that
the respective functions are active.
The operating 昀椀elds also have other functions assigned to them and they are explained in
detail in the corresponding chapters.
Pressure Display
The needle on the pressure display (32) indicates the brewing pressure while preparing espresso.
Ideally, the needle should be in the "Espresso" section. If the needle is outside this section during
preparation, you should adjust the settings for your espresso (see the "Programming Your Own
Settings" chapter and "Tips" chapter).
Steam Power Control
The steam power control (8) is used to regulate the emission of steam and hot water (Picture C):
In this position no steam is emitted.
In this position steam is emitted.
In this position hot water is emitted.
When you switch on the device, always make sure that the steam power control is in the
position!
Hotplate
On the hotplate (7) you can preheat your cups or keep espresso that you have made warm.
As soon as the device heats up, the hotplate is automatically heated at the same time.
Programming Your Own Settings
The grinding 昀椀neness and the amount of coffee powder which is ground in each grinding process
can be set individually. The amount of water for the single or double espresso can likewise be
individually programmed separately.
New settings cancel the factory default settings and are retained even if there is a power
cut or when the device is disconnected from the mains power.
To restore the device to the factory settings, touch the 昀椀elds
simultaneously until a beep is heard.
(29)
(35) and
46
Publicidad
