Beem ESPRESSO-GRIND-EXPERT Manual De Instrucciones página 49

49
Preparation
Inserting / Removing the Drip Tray
The device is supplied with a drip tray (13) because espresso may drip from the porta昀椀lter (16)
after the cup has been removed.
1. Insert the drip tray into the bottom of the device. Insert it at a slight angle so that the drip tray
can lock in place. Make sure that it 昀椀ts correctly in the device.
2. Place the storage plate (15) on the drip tray.
3. To remove the drip tray, tilt it forwards slightly and carefully pull it out of the device.
Behind the drip tray there is a small drawer for the cleaning utensils (18). Insert this into the
designated compartment (11) before you insert the drip tray.
Filling the Water Tank
PLEASE NOTE!
Do not pour milk or other liquids into the water tank. Only ever use water!
•
1. Take the water tank (6) off the device by pulling it upwards.
2. Open the water tank lid (5).
3. Pour water into the water tank. Make sure that you 昀椀ll it at least up to the MIN marking and
no higher than the MAX marking.
4. Close the water tank lid.
5. Insert the water tank into the device by sliding it into the device from above. Make sure that
the locking lugs of the water tank sit in the recesses which are provided for them on the
device. You must feel it engage.
If the device notices that the water tank does not have enough water in it, all operating
昀椀elds 昀氀ash and a beep is heard.
Adding Espresso Beans
1. Make sure that the bean container (1) is inserted correctly (see the "Cleaning and Care"
chapter – "Cleaning the Grinder").
2. Remove the lid (2) from the bean container.
3. Fill the bean container with espresso beans. Do not over昀椀ll it!
4. Place the lid back on the bean container.
When you switch to another type of espresso, there will still be coffee powder from the
previous type in the grinder (3). The grinder may need to be cleaned beforehand (see the
"Cleaning and Care" chapter – "Cleaning the Grinder").
EN