Publicidad
Idiomas disponibles
Idiomas disponibles
OMNIA M 3.2
3. The automatic setting curve for heating mode
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
State:In the setting the wired controller, if T4H2<T4H1, then exchange their value; if T1SETH1 <T1SETH2, then exchange
their value.
4. The environment temperature curves of the low temperature setting for cooling mode
T4
1-T1S
2-T1S
3-T1S
4-T1S
5-T1S
6-T1S
7-T1S
8-T1S
5. The environment temperature curves of the high temperature setting for cooling mode
T4
1-T1S
2-T1S
3-T1S
4-T1S
5-T1S
6-T1S
7-T1S
8-T1S
6. The automatic setting curve for cooling mode
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
State: In the setting the wired controller, if T4C2<T4C1,then exchange their value; if T1SETC1<T1SETC2, then exchange
their value.
10.2 DIP switch settings overview
10.2.1 Function setting
DIP switch is located on the hydraulic module main control board (see "9.3.1 main control board of hydraulic module") and
allows configuration of additional heating source thermistor installation, the second inner backup heater installation, etc.
22T÷30T
-10≤T4<15
15≤T4<22
16
11
17
12
18
13
19
14
20
15
21
16
22
17
23
18
-10≤T4<15
15≤T4<22
20
18
21
19
22
20
23
21
24
21
24
22
25
22
25
23
Cod. 3QE47660 - Rev. 00 - 02/2022
22≤T4<30
30≤T4
8
5
9
6
10
7
11
8
12
9
13
10
14
11
15
12
22≤T4<30
30≤T4
17
16
18
17
19
17
19
18
20
18
20
19
21
19
21
20
123
EN
Publicidad
