SICK HTB18 Manual De Instrucciones página 33

1.3 Intended use
8017850.1HW2/2022-11-14 | SICK
Subject to change without notice
This product does not constitute a safety component as defined in the
NO
Machinery Directive.
2006/42/EC
SAFETY
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
Laser notes
HTB18L:
CAUTION
Interference, manipulation or incorrect use can lead to hazardous exposure due to laser
radiation.
The emitted light beam must not be focused by means of additional optical devices.
LASER
1
Figure 8: Laser class 1
This device complies with the following standards:
•
EN/IEC 60825-1:2014
•
21 CFR 1040.10 and 1040.11 except for tolerances according to Laser Notice No.
56 dated May 8, 2019.
The laser is eye-safe.
The laser marking is located on the housing imprint on the sensor.
The HTB18 is an opto-electronic photoelectric background suppression proximity sen‐
sor (referred to as "sensor" in the following) for the optical, non-contact detection of
objects, animals, and persons. If the product is used for any other purpose or modified
in any way, any warranty claim against SICK AG shall become void.
The HTB18L is an opto-electronic photoelectric background suppression proximity sen‐
sor (referred to as "sensor" in the following) for the optical, non-contact detection
of objects. If the product is used for any other purpose or modified in any way, any
warranty claim against SICK AG shall become void.
OPERATING INSTRUCTION
O P E R A T I N G I N S T R U C T I O N | HTB18(L) 33