Wilier SLR36GRV Manual De Uso Y Mantenimiento página 11

COMPLETE WHEELS
4
SLR36GRV wheels are designed to fit Tubeless Ready
tyres only.
Be very careful to avoid situations which you may
incur in direct and violent impacts with potholes or
unevenness of the road surface as this might cause
the rim cracking and the consequent loss of warranty.
In the event of abnormal impacts due to uneven road
surfaces or during wheels transport, we recommend
to have the wheels immediately checked by a
specialised mechanic or qualified personnel.
SLR36GRV wheels are uniquely sold with the Tubeless
Ready conversion kit certified by our Quality
Department; please read carefully the instructions in
sections I, II and III.
I_FITTING THE TUBELESS TYRE HOOKLESS
COMPATIBLE
Warning
!
If you have any doubt about your ability to carry out
the following operations, please consult qualified
personnel.
Always wear protective gloves and goggles before
any maintenance work on your wheels.
Check that the tyre bears the Tubeless Ready logo
If required to use a lever to insert the tyre beads, use a
plastic lever so to not damage the rim and tape.
To install the Tubeless ready tyre, please follow the
following simple steps:
- Moisten the base of the rim with soap and water.
- Starting from the valve area, insert the firstof the
two tyre beads into place, and continue along the
entire circumference of the wheel.
- Fit the other bead of the tire and continue around
the whole circumference of the rim: check the
correct positioning of the tire on both sides of the
valve zone. Ensure the correct positioning of the tire
moving slightly back and forth the tire.
If the tyre is too easy to fit, the tyre may be too big.
Caution, a tyre that is too big could deflate suddenly
and cause an accident, serious injury or death.
II_INFLATING THE TUBELESS TYRE HOOKLESS
COMPATIBLE
Warning
!
If you have any doubt about your ability to carry out
the following operations, please consult qualified
W I L I E R . C O M
personnel.
Always wear protective gloves and goggles before
any maintenance work on your wheels.
Before inflating the Tubeless ready tyre, insert the
anti-puncture liquid (Caution, do not use products
containing ammonia) following these simple steps:
-Remove the valve cap.
- Using your index finge, gently press the top of the
valve so as to ensure there is no air inside the tire.
- Remove the top part of the valve using the
appropriate tools.
- Insert the anti-puncture liquid using the appropriate
dispenser.
- Spin the wheel around several times to distribute
the liquid throu-ghout the inside of the tire.
- Put the top part of the valve back into place.
- Make sure the two tire beads are positioned
correctly by verifying that the distance between
the center line of the tyre and the edge of the rim is
constant through the entire wheel.
- Inflate the tyre. Warning, follow the steps in section
2 of the General Indications.
- Put the valve cap back.
- Have a ride of 3-4 kms to ensure the liquid inside the
tyre will evenly distribute.
In the event of a tyre puncture, the loss of air is slow
and not immediate, and in some cases offers you the
possibility of continuing your ride home. Keep in mind
that a Tubeless ready tyre can be repaired by applying
a tyre patch, by using an anti-puncture spray, or by
installing an inner tube.
# L OV E M Y W I L I E R
SLR36GRV
1 1