Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR Lithonia Lighting TCC
1. Remove the side cover by unscrewing the two side screws and remove side cover. (See Fig. R)
2. Slide out front panel, if applicable, to permit installation process. Installer will need to remove bonding screw on Standard
Exit Signs.
SIDE SCREWS
BACK PANEL
3. To use with a pendant, remove the battery screws, and battery tray and remove the top middle knockout (See Fig S). Pull
harness back through hole for top pendant mount (See Fig I).
BATTERY TRAY SCREW
ND
(2
SCREW IS DIRECTLY
ACROSS ON THE RIGHT SIDE)
PAGE: 13 of 19
LED Steel Combo Emergency Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
PENDANT MOUNT INSTALLATION
(Pendant mount not included)
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
BONDING SCREW
Fig. R
Fig. S
Standard Exit Sign
MIDDLE KNOCK OUT
BATTERY TRAY
Publicidad
