INSTRUCTIONS FOR Lithonia Lighting TCC
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
OPERATION:
1. To test the equipment, depress the TEST switch, the emergency lights will illuminate.
2. Once you release the TEST switch the emergency lights will turn OFF and the LED indicator will illuminate green for
charging.
3. The charger board will continue charging the battery to maintain a fully charged state.
NOTE: Allow the battery to charge for a minimum of 24 hrs after installation or after a power failure before conducting a
90-minute test.
NOTE: Standard and HO are furnished with a sophisticated solid state transfer switch which will automatically disconnect
the emergency lights from the battery if the battery has been discharged to the end of its useful output. Sign will still
illuminate during AC power only.
MAINTENANCE:
CAUTION: Always turn OFF AC power to the equipment before servicing. Operator should disconnect battery if the lamps are
on to remove power from lampheads before service lampheads. Servicing should be performed only by a qualified service
technician. Only manufacturer SUPPLIED or APPROVED replacement parts must be used.
BATTERY: The battery supplied with this unit requires ZERO maintenance. However, it should be tested periodically and replace
when it no longer operates the connected fixtures for complete duration of a monthly 30-second or annual 90-minute test.
NFPA 101 (current Life Safety Code) requires that all emergency lighting equipment be functionally tested every 30 days for a
minimum of 30 seconds and tested annually for full 90-minute duration. Written records of the testing are to be kept for
examination by the authority having jurisdiction.
Remote Loading Limits
Product
TCC HO
PAGE: 17 of 19
LED Steel Combo Emergency Unit
TCC
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
Maximum Continuous Remote Loading
6.6W
2.4W