Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR Lithonia Lighting TCC
11. Standard Exit Sign. Slide Standard Exit Panel into grooves (See Fig D), with Standard Exit Panel facing out, and torque
bonding screw to 10.6 in-lbs. (1.2Nm) Proceed to step 15. It may simplify installation if you allow the colored diffuser to side
into the far groove ahead of the metal plate. Torque the bonding screw s to 10.6 in-lbs (1.2Nm). If double-sided panel is
desired, remove backplate and add panels to both sides. Proceed to step 15.
BONDING SCREW
Note: There is a
similar screw on
the backplate that
if removed should
be torqued to the
same value.
12. Running Man: Place the Running Man sign over the white diffuser and slide stacked signs into the grooves with Running Man
panel facing outward, RM no Arrow panel is shown. If double-sided panel is desired, remove back plate and add panels to
both sides. (See Fig. E).
RM PANEL
PAGE: 4 of 19
LED Steel Combo Emergency Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
BACK MOUNT INSTALLATION
GROOVES
DIFFUSER
GROOVES
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
Fig. D
Fig. E
(CONT.)
Publicidad
