Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR Lithonia Lighting TCC
1. Remove the side cover by unscrewing the two side screws and remove side cover. (See Fig. G)
2. Slide out front panel, if applicable, to permit installation process. Installer will need to remove bonding screw on Standard
Exit Signs.
SIDE SCREWS
BACK PANEL
3. To use with a canopy, remove the canopy screws and remove the desired knockout (See Fig H). Side canopy mount is shown.
The battery tray will also need be removed to route harness through the desired knockout, then reinstall battery tray (See Fig
I, J, K, and L). For top mount, while battery tray is removed, lamps need to be moved to the side or removed. See Relocating
Lampheads to Side for Top Mount section to move lampheads and then proceed with installation.
TOP SIDE CANOPY SCREWS
PAGE: 6 of 19
LED Steel Combo Emergency Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
TOP/SIDE MOUNT INSTALLATION
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
BONDING SCREW
Fig. G
Fig. H
Standard Exit Sign
KNOCKOUTS
SIDE MOUNT CANOPY SCREWS
Publicidad
