Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR Lithonia Lighting TCC
4. Mount the pendant to the top of unit using ½" Threaded Nipple Conduit Fitting, and a ½" Threaded Conduit Coupler Fitting.
Ensure the Pendant mount does not interfere or make contact with the battery when the tray is installed. (See Fig T)
½" THREADED
COUPLING CONDUIT
FITTING
½" THREADED
NIPPLE CONDUIT
FITTING
5. Pull the harness back through the hole and feed into through the pendant, reinstall the battery tray, and torque the screws to
10.6 in lbs (1.2 N ms) (See Fig I and J).
6. Use code-approved connectors to make the connection inside the unit. Connect the hot wire to the red lead. Connect neutral
wire to the white lead. The ground wire (green lead) needs to be connected in accordance with the local codes. DO NOT
energize the circuit at this time (See Wiring Diagram). For Units with Remote Lamp Wires: Connect remote wires to the
remote output. The yellow wire is the positive remote wire and blue is the negative (See Wiring Diagram). If no remote
lamps are connected, make sure remote wire harness is removed from the unit to prevent shorting.
7. Proceed to step 10 for Chicago Panel.
8. Proceed to step 11 and 12 for Standard Exit Sign.
9. Proceed to step 13 for Running Man.
10. Chicago Glass Sign: Slide Chicago Glass Panel into grooves (See Fig U). If a double-sided panel is wanted add panels to both
sides. Proceed to step 16.
GROOVES
PAGE: 14 of 19
LED Steel Combo Emergency Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
PENDANT MOUNT INSTALLATION
(Pendant mount not included)
SLIDE PANEL
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
PENDANT
½" CONDUIT
Fig. T
Fig. U
(CONT.)
½" THREADED
CONDUIT COUPLER
FITTING
½" THREADED
NIPPLE CONDUIT
FITTING
UL924 CERTIFIED GLASS PANELS
CHP ENA
CHP SNA
CITY OF CHICAGO, IL
NON UL924 CERTIFIED
GLASS PANELS
CHP SRA
CHP ERA
CHP SLFA
CHP ELFA
CHP SDA
CHP EDA
Publicidad
