Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR Lithonia Lighting TCC
11. Standard Exit Sign: Slide 1 Red or 1 Green Diffuser into Standard Exit Panel Grooves (See Fig V).
REMOVE RED DIFFUSER
12. Standard Exit Sign: Slide Standard Exit Panel into grooves (See Fig W) and torque bonding screw to 10.6 in-lbs (1.2Nm) . If a
double-sided panel is desired, add panels to both sides. It may simplify installation if you allow the colored diffuser to side
into the far grove ahead of the metal plate. Torque bonding screws on both sides (front and back). Proceed to step 16.
BONDING SCREW
Note: There is a
similar screw on
the backplate that
if removed should
be torqued to the
same value.
13. Place the Running Man sign over the white diffuser and slide both into grooves, RM Arrow panel is shown (See Fig. X). If a
double-sided panel is wanted add panels to both sides.
RM PANEL
PAGE: 15 of 19
LED Steel Combo Emergency Unit
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
PENDANT MOUNT INSTALLATION
(Pendant mount not included)
REMOVE DESIRED CHEVRON(S)
SLIDE PANEL
GROOVES
WHITE DIFFUSER
GROOVES
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
REPLACE WITH RED OR GREEN DIFFUSER
Fig. V
Fig. W
Fig. X
(CONT.)
Publicidad
