Acuity Brands Lithonia Lighting TCC Manual De Instrucciones página 4

Idiomas disponibles

INSTRUCTIONS FOR Lithonia Lighting TCC

4. Use code-approved connectors to make the connection inside the unit. Connect the hot wire to the red lead. Connect neutral

wire to the white lead. The ground wire (green lead) needs to be connected in accordance with the local codes. DO NOT

energize the circuit at this time (See Wiring Diagram). For Units with Remote Lamp Wires: Connect remote wires to the

remote output. The yellow wire is the positive remote wire and blue is the negative (See Wiring Diagram). If no remote

lamps are connected, make sure remote wire harness is removed from the unit to prevent shorting. Wires shall be neatly

dressed inside the unit to prevent any shadowing of the exit sign (i.e., routed closely to side of unit).

5. Connect the battery to the main board. Refer to the wiring diagram below.

6. Proceed to step 9 for Chicago Glass Panel.

7. Proceed to step 10 and 11 for Standard Exit Sign.

8. Proceed to step 12 for Running Man Panel.

9. Chicago Glass Panel. Slide Chicago Glass Panel into grooves (See Fig B). Proceed to step 13.

SLIDE PANEL

GROOVES

10. Standard Exit Sign: If directional chevron is desired slide red diffuser out and knockout desired chevron. Replace red diffuser

or use green diffuser if desired. (See Fig C)

REMOVE RED DIFFUSER

PAGE: 3 of 19

LED Steel Combo Emergency Unit

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

BACK MOUNT INSTALLATION

Fig. B

REMOVE DESIRED CHEVRON(S)

Fig. C

SAVE THESE INSTRUCTIONS

and deliver to owner after installation

(CONT.)

UL924 CERTIFIED GLASS PANELS

CHP ENA

CITY OF CHICAGO, IL

NON UL924 CERTIFIED

GLASS PANELS

CHP ERA

CHP ELFA

CHP EDA

REPLACE WITH RED OR GREEN DIFFUSER

CHP SNA

CHP SRA

CHP SLFA

CHP SDA