Roger Technology B71/PBX Instrucciones Y Advertencias Para El Instalador página 55

8
Display and function buttons
When the display is not lit up, press any of the keys around it to reactivate the back-lighting; when it is already lit up,
press a key to navigate the menus and activate automatic switch-off after 60 seconds.
If the display switches off (standby), press the
on the LCD display.
WARNING: avoid disconnecting and reconnecting the power supply, as this will cause the battery charge
status information to be lost (and only recovered at the end of a complete charging cycle).
9
Light signals
LED DESCRIPTION
SEC1 ON if voltage is detected on the SEC1 terminals
ON if voltage is detected on the SEC2 terminals. Always OFF in the
SEC2
case of B71/PBX24 (SEC2 not used)
BATT Indicates the status of the batteries (*)
PANEL Indicates the status of the photovoltaic panel (*)
(*) In battery operation, these LEDs are OFF when the display back-lighting is disabled (press any of the keys around
the display to reactivate it).
Flashing slowly:
Brief switch-off every 2":
Fixed ON (BATT only):
10
Navigation in the menus
For subsequent MENUS:
1.
2. By clicking on or the down arrow
3. By clicking ENTER, the sub-menu is accessed, which in turn can have other options that can be changed or only
consulted.
4. With the + and -
5. To return to the previous level, press ESC; the value set on the display will be saved in the memory.
BUTTON DESCRIPTION
Returns to the display of the MENU page / moves the cursor
upwards to select the MENU option
Moves forwards with the display of the MENU page / moves the
cursor downwards to select the MENU option
ENTER
pressing it again, it enters the option, allowing to modify it.
Exit from the menu / previous level / saving the set value
ESC
Value increase
+
Value decrease
-
and keys for 5 seconds to reactivate it; the image will appear again
the battery (if LED BATT) or panel (if LED PANN) to verify the alarm icons. If one of
assessment phase in progress
current being supplied
battery charging in progress
the cursor moves from one menu option to another.
BATT PANEL
ENTER
ESC
55