Roger Technology B71/PBX Instrucciones Y Advertencias Para El Instalador página 66

11.9SERIAL communication menu (with optional interface - FUTURE USE)
The indicated data is only indicative.
By connecting a special adapter to the ADTSER connector, certain information can be sent to a PC using
the MODBUS communication protocol.
COM
ENTER
ENABLE
BAUDRATE
PERIOD
TARGET
ENTER
11.10WiFi menu (with B74/BCONNECT)
The indicated data is only indicative.
By connecting the Roger B74/BCONNECT module to the WIFI connector of the B71/ PBX, it is possible to
COM
ENTER
TRAFFIC
QUALITY
dBm ROUTER
STATUS
ENTER
66
SERIAL
WIFI
POWERSAVE
RTCC
ESC
OFF
----
----
----
ESC
SERIAL
WIFI
POWERSAVE
RTCC
ESC
WAIT
100%
---
APx/CL
ESC
ON = serial communication enabled
OFF * = serial communication disabled
(*) If there is no device connected on the ADTSER
connector, make sure it is always set to OFF.
Selection of the communication BAUDRATE.
Selectable values: 9600, 19200, 38400, 57600, 115200
Selection of the time interval for sending data, in seconds
(frequency of LOG events, future use).
Selecting the type of serial device connected
- RTCC B71/PBX/RTCC
- PCLOG logger on PC (future use)
- DEBUG for technical assistance only
Return to the previous menu
NOTE: the menu is in read-only format
indicates that the B74/BCONNECT module is not
connected or, if it is connected, the communication with
B71/PBX is not active. In normal conditions, you can see
the alternation of the words "INFO" and "SYST".
indicates the percentage of communication attempts
is generally 100%
ROUTER DBM indicates the signal strength of the WiFi
router to which B74/BCONNECT is connected; IDLE
indicates if there is no connection.
If "CL" is enabled, this means it's connected to the Cloud.
"AP", followed by a number, indicates an "Access Point"
type connection and the count of the A.P. connections.
Return to the previous menu
COM
COM