Roger Technology B71/PBX Instrucciones Y Advertencias Para El Instalador página 67

11.11POWERSAVE menu
The indicated data is only indicative.
This feature saves battery consumption at night. In order to maintain the time accuracy it is necessary to
have a source of exact time: if in fact B71/PBX would be turned off because the battery is too low, the time
setting would be backward, assuming the last value saved in memory (periodic saving).
To have the exact time there are two possibilities:
1) use B74/BCONNECT
2) use the radio receiver with RTCC (B71/PBX/RTCC - Real Time Clock Calendar) that in addition allows
the awakening of the central unit at the reception of the radio command
COM
ENTER
ENABLE
PWS START:
PWS STOP:
PWS DELAY:
ENTER
Return to the previous menu
EXAMPLE
ENABLE
PWS START:
PWS STOP:
PWS DELAY:
ENTER
21.00
CONTROL UNIT CONTROL UNIT
OFF
ON
SERIAL
WIFI
POWERSAVE
RTCC
ESC
OFF
00:00
00:00
5min
ESC
ON
21:00
06:00
5 min
ESC
5 min.
CONTROL UNIT
ON OFF
ON = POWERSAVE enabled
OFF = POWERSAVE disabled
Select the hours/minutes of the start and end of the
time slot in which B71/PBX will cut power to the control
unit (ATTENTION! In the absence of an RTCC receiver
accessory that allows the control unit to "wake up", the
automation will no longer be available in that time slot,
it will remain off).
Setting of the delay, in minutes, with which B71/PBX
returns to PowerSave mode, switching off the control
unit.
NOTE: this menu step is managed only if B71/PBX/
RTCC is installed, because it makes sense only if the
receiver able to wake up the central unit is installed. If not
installed, "----" appears.
Minimum selectable delay: 5 minutes.
ATTENTION! If you set PWS STOP at a time that is a few
minutes earlier (e.g. 20.55) than PWS START (21.00), the
control unit will remain off for almost 24 hours.
06.00
CONTROL UNIT
ON
COM
67